Operation Of The Leds - ADEUNIS Sigfox Smart Building COMFORT Guide Utilisateur

Sigfox Smart Building COMFORT - Guide utilisateur / User guide version V1.0.1
NOTE: It is possible to program the sending of a frame only after a certain number of edge detections (S381/S383).
Product in standby
State
change
on digital
input(s)?
Yes
Number of
occurrences
reached?
Send frame 0x51 or
0x52

2.2. Operation of the LEDs

Mode
Device in Park/Storage mode
Long button press (2 seconds) in PARK mode
Starting the device (after detecting long
button press)
Switching to command mode
Low battery level
Device in default (return to factory)
Button press in OPERATING mode
Device in DEAD mode
* The green and red LED lights simultaneously give a white/yellow rendering through the case.
Eg:
Register Value code
S382 Hexadecimal 0x41
No
S383 Decimal
* Debounce time: minimum time to take account of a change of state. For example, if this period is 10 ms
all pulses (high or low level) whose duration is less than 10 ms will not be considered. This technique avoids
potential rebounds during a change of state.
No
In this example the device:
• The device has a debounce time of 100 ms and the button press alarm is enabled (register
383).
• The device sends a frame as soon as it has detected 5 high edges on its digital input per termi-
nal block (register S382)
The digital input operates only in event mode (no periodic sending).
LED red state
OFF
-
-
Continuously lit*
Flashing (500ms ON every 60s)
Fixed
ON for 500 ms *
Flashing (100ms ON / 100ms OFF) x2 every
5s
DISTRIBUTED BY TEXIM EUROPE
Value Result
Configuration of the Digital Input 2
input (terminal block):
• Detection of high edges
• Debounce time* 100ms
5 The device sends a frame every 5
times that a high edge is detected on
Digital Input 2
LED green state
OFF
ON when you press button for 1 second
Fast flashing 6 cycles 100 ms ON / 100 ms
OFF
Continuously lit*
-
-
ON for 500 ms *
-
FR
EN
Page 61 of 85