Correct Positioning Of The Device; Fixing With Screws; Starting Up The Device Using The Button - ADEUNIS Sigfox Smart Building COMFORT Guide Utilisateur

Sigfox Smart Building COMFORT - Guide utilisateur / User guide version V1.0.1

5.5. Correct positioning of the device

Position: To the extent possible, install the transmitter at a min-
imum height of 1.50 m in a non-enclosed area. Do not position
the sensor in front of a window or in the sun.
This device has been designed for indoor use.
CAUTION: the upper face of the device (allowing the opening
of the casing) must be accessible with a screwdriver. Do not
position the device against a ceiling or under an object only to
find that you are no longer able to open the casing.

5.6. Fixing with screws

The product is delivered with 2 CBLZ 2.2 x 19 mm screws and 2 SX4 wall plugs. Use these products or equivalent products in order to fasten
your device onto a flat support.

5.7. Starting up the device using the button

Once the device has been configured, it is ready to be started up. To start the device: press the button for 5 seconds (see diagram), the green
LED lights up and flashes quickly.
Once the device has been validated, it sends its status frames and then, after the defined transmission period time, a data frame.
1.50 m
DISTRIBUTED BY TEXIM EUROPE
FR
EN
Page 79 of 85