RIB K800 FAST FCE Mode D'emploi page 29

MOTOR AND RACK FITTING
N.B.: To use metal rack only code ACS9050.
The holes for fixing the metal rack must be made at 130 mm height from the motor
support.
The height of the rack can be adjusted thanks to the slots available on its right -angled
bar.
The height adjusting is necessary to prevent the gate leaning on the driving gear (5 and
6).
To fasten the iron rack on the gate, drill Ø 7 mm holes on the moving part of the gate and
thread them using a M8 tap thread.
The driving gear needs some 1 mm clearance from the rack.
Measurements in mm/inch
LIMIT SWITCH FITTING
In order to determine the travel of the moving part, place two cams at the ends
of the rack (Fig. 7-8).
Move the cams on the rack teeth to adjust their opening and closing travel.
To fix the cams to the rack, tighten the screws issued.
N.B: In addition to the electric stop cams mentioned above, you must also install strong
mechanical stops preventing the gate from sliding out of the top guides.
MAINTENANCE
To be carried out exclusively by skilled persons after the power supply to the
motor has been interrupted.
Periodically, when the gate is standstill, clean and keep the guide free from stones and
dirt.
6,6"
1,5"
5
29
6,6"
1,5"
10,6"
0,04"
Measurements in mm/inch
K FCE
K FCM
G
B
6
7
8