Help In Case Of Malfunction - AL-KO solo CS 4235 Mode D'emploi

Help in case of malfunction

Battery
Rated voltage
Rated capacity
Charging duration
Charging unit
Mains voltage
Mains frequency
Output voltage
Operating temperature range
14 HELP IN CASE OF MALFUNCTION
CAUTION!
Risk of injury
Sharp-edged and moving appliance parts can lead to injury.
■
Always wear protective gloves during maintenance, care and cleaning work.
■
Switch off the appliance and remove the rechargeable battery.
Malfunction
Engine does not run.
The guide rail and saw chain
become hot when running.
Generation of smoke.
Motor running, but the saw
chain does not move.
Only sawdust is thrown out,
rather than wood chips. The
chain saw has to be pushed
through the wood.
Appliance vibrates unusually.
469892_a
Cause
No battery voltage present.
Overload protection has
switched off.
Chain brake engaged.
The saw chain is tensioned
too tightly.
Oil tank is empty.
The oil entry hole and/or
groove of the guide rail are
dirty.
The saw chain is tensioned
too tightly.
Appliance faults
The saw chain is blunt.
Appliance faults
127390
36 V / 42 V max.
7.5 Ah
approx. 150 min
127391
230 V (AC)
50 Hz
42 V (DC)
0 °C – +40 °C
Remedy
Have the power supply checked by
a qualified electrician.
Wart until the overload protection re-
establishes the power supply.
Release the chain brake.
Reduce chain tension.
Replenish the saw chain oil.
Inspect the oil tank for damage.
Clean the oil entry hole and groove
of the guide rail.
Reduce chain tension.
Contact an AL-KO service centre.
Sharpen the saw chain or contact an
AL-KO service centre.
Contact an AL-KO service centre.
55