Charging The Rechargeable Battery (06, 07); Filling Saw Chain Oil (08) - AL-KO solo CS 4235 Mode D'emploi

GB
WARNING!
Danger of serious injury.
Serious injury can be caused if there are
damaged components on the chain saw.
■
Before each use, perform a visual
inspection in order to check that the
chain saw is complete and does not
contain damaged or worn compo-
nents. Safety and protective devices
must be intact.
5.1 Charging the rechargeable battery (06,
07)
CAUTION!
Danger of fire during charging!
Due to heating of the charger, there is a
danger of fire if it is placed on an inflam-
mable surface and is not adequately
ventilated.
■
Always use the charger on a non-in-
flammable surface or in a non-com-
bustible environment.
■
If available: Keep the ventilation
slots free.
NOTE
Fully charge the rechargeable battery
before using it for the first time. The re-
chargeable battery can be charged in
any charge status. Interrupting charging
does not damage the rechargeable bat-
tery.
NOTE
When charging, the rechargeable bat-
tery is protected from overcharging due
to automatic detection of the charge sta-
tus and thus can remain connected to
the charging unit for some time, but not
permanently.
NOTE
Heed the separate operating instructions
for the rechargeable battery and for the
charging unit.
1. Connect rechargeable battery (06/1) to char-
ger (06/2, 06/a), and charger (06/3, 06/b) to
the mains voltage. The charging process be-
gins. The LED on the charging unit lights
44
green, the charge status is displayed on the
rechargeable battery.
2. Observe the charge status displays on the re-
chargeable battery (07). The charging pro-
cess takes approx. 2.5 hours until fully
charged. The charging process ends auto-
matically when the rechargeable battery is
fully charged.
3. Disconnect the rechargeable battery from
charger (06/a) and the charger from the
mains voltage (06/b).
5.2

Filling saw chain oil (08)

IMPORTANT!
Danger of damaging the chain saw
The chain saw will be severely damaged
if there is too little or even no saw chain
oil in the tank or if it has dried/is sticky.
Dried/sticky saw chain oil can lead to
damage to oil-channelling components
and the oil pump.
Damage also occurs if used oil is used.
The use of used oil leads to environmen-
tal damage!
■
For start-up work, fill saw chain oil
into the tank.
■
Do not use any used oil!
■
Each time before changing the re-
chargeable battery at the latest, fill
the tank with saw chain oil again.
The saw chain and the guide rail are continuously
supplied with oil during operation by means of an
automatic oiler system. The saw chain oil pro-
tects against corrosion and premature wear.
There must always be sufficient saw chain oil in
the tank to lubricate the saw chain sufficiently.
Use only environmentally friendly, biodegradable,
high-quality saw chain oil for lubrication of the
saw chain and guide rail. This oil must be trans-
ported and stored in approved and appropriately
labelled containers.
Each time before starting work or changing the
rechargeable battery, check the oil level and re-
plenish the saw chain oil if necessary:
1. Check the oil level in the viewing aperture of
the tank (08/1). It must always be possible to
see oil. The minimum and the maximum oil
level must not be exceeded.
2. Refill saw chain oil via filler neck (08/2) if nec-
essary.
Start-up
CS 4235