Possible Foreseeable Misuse; Residual Risks; Safety And Protective Devices; Switch-On Protection - AL-KO solo CS 4235 Mode D'emploi

Product description
thus decline any responsibility for damage and/or
injury suffered by the user or third parties.
CAUTION!
Danger of injury due to non-designat-
ed use!
If wood or other substances embedded
with foreign bodies are sawn with the
chain saw, injury can result.
■
Only use the chain saw for light
wood sawing work.
■
Before sawing wood, check for for-
eign bodies, e.g. nails, screws, fit-
tings.
2.2

Possible foreseeable misuse

■
Do not saw off any branches that are directly
or at an acute angle above the user or other
persons.
■
Do not use old oil or mineral oil for lubrication
of the saw chain.
■
Do not use the tool in a potentially explosive
atmosphere.
2.3

Residual risks

Even when using the appliance as intended,
there is always a certain residual risk that cannot
be excluded. The following hazards cannot be
ruled out due to the nature and design of the ap-
pliance.
■
Contact with the exposed teeth of the chain
(risk of cutting)
■
Access to the moving chain (risk of cutting)
■
Sudden and unexpected movement of the
bar (risk of cutting)
■
Detachment of parts of the chain (risk of cut-
ting/injury)
■
Detachment of parts of the wood being
worked on
■
Impairment of hearing during work if ear de-
fenders are not used
469892_a
2.4

Safety and protective devices

WARNING!
Danger of serious injury from manip-
ulated safety and protective devices
As a result of manipulated safety and
protective devices, serious injury can oc-
cur when working with the chain saw.
■
Never deactivate safety and protec-
tive devices.
■
Only work with the chain saw if all
safety and protective devices func-
tion correctly.
2.4.1

Switch-on protection

If the operator applies the throttle quickly several
times in succession, the chain saw switches off
for a few seconds to protect the electronics and
the saw chain. In this case, wait until the chain
saw can be switched on again.
2.4.2

Chain brake/chain brake bracket

The chain saw has a manual chain brake that is
triggered by the chain brake bracket, for example
if kickback occurs. If the chain brake is tripped,
saw chain and motor are stopped immediately.
2.4.3

Overload protection

The chain saw is equipped with an overload pro-
tection which switches off in case of overload.
After a cooling-down phase, the chain saw can
be switched on again.
2.5

Symbols on the appliance

Symbol Meaning
Pay special attention when handling
this product.
Danger of kickback!
Do not operate the chain saw with
one hand!
Do not use in the rain! Protect
against moisture!
35