Power Supplies (Overview) - AirSep Focus Manuel

Focus™
[Read the Important Safety Rules section before operating this equipment]

Power Supplies (Overview)

Focus can be powered in four different ways Ŕ the battery, AC power, DC power,
or an optional AirBelt. The Focus power supply functions both as an AC power
supply and a DC power supply.
(Refer to Connecting to Focus's Power Inlet section for specific
instructions regarding the connection of optional power sources.)

Battery: Two rechargeable batteries are supplied with Focus. Each battery,
when fully charged, supplies power to the Focus unit for up to 1 ½ hours.
An audible alarm sounds when the battery power is getting low. The alarm
is discussed in the Audible Alarm and Indicator Lights section of this
manual. The 25% capacity LED will blink every ½ second to indicate a low
state of charge when the button is pressed.
During this condition, change to another battery or alternate power
source.

Battery Charging (Battery Charging section): To charge the battery,
connect the battery to either the power supply and a 100-240 volt,
50/60 Hz AC power outlet, or connect the power supply to a DC power
outlet in an automobile (boat, motor home, etc.). A discharged battery
requires approximately four hours to fully charge. It is recommended to
recharge the battery, even if only partially depleted, as often as possible.

Universal Power Supply

The AC power supply side of the universal power supply, allows the
Focus unit to connect to a 100-240 volt, 50/60 Hz outlet. The power
supply converts 100-240 volt AC to a DC voltage for the Focus unit to
operate while recharging the Focus battery simultaneously.

The DC power inlet on the universal power supply, allows the Focus unit
to connect to a motor vehicle's 12-Volt DC outlet for the Focus unit to
operate while recharging Focus's battery simultaneously.

Optional AirBelt: Focus can also be powered with AirBelt. AirBelt can be
worn around the waist. When fully charged, the battery supplies power to
Focus for up to 4 hours. AirBelt connects to the Focus unit's power inlet.
It can be recharged by connecting it only to the AirBelt AC power supply.
®
AirSep Corporation
MN172-1 rev. A - 02/13
EN
EN-25