AirSep Focus Manuel page 195

Focus™
®
AirSep Corporation
MN172-1 rev. A - 02/13
Do not allow either the air intake or the air outlet vents to
become blocked. This can cause the Focus unit to overheat
and affect performance.
Do not operate unit in a restricted or confined space (i.e.,
a small case or handbag) where ventilation can be limited. This
can cause the Focus unit to overheat and affect performance.
When using Focus in an automobile, boat, or on other DC
sources with the Universal AC/DC power supply, make sure
that the vehicle is started and running before connecting the
Focus unit. If the DC power supply does not illuminate and
requires resetting, disconnect the DC power supply from the DC
outlet, restart your vehicle, and then reconnect your DC power
supply into the DC outlet. Failure to follow these instructions
can result in the power supply not supplying power to Focus.
When the automobile in which you are using the Focus unit is
turned off, disconnect and remove the unit from the automobile
with you. Do not store Focus in a very hot automobile or in
other similar, high-or low-temperature environments. Operating
or storing the unit outside the normal temperature range can
affect the performance of the Focus. (Refer to the
Specifications section in this manual.)
If the Focus has been stored for an extended period of time
outside its normal operating temperature range, the unit should
be allowed to return to normal operating temperature before
being turned on. (Refer to the Specifications section in this
manual.)
Replace the disposable cannula as recommended by the
manufacturer or your equipment provider. Additional supplies
are available from your Equipment Provider.
Do not position the Concentrator so that it is difficult to access
the power cord.
The concentrator should be located as to avoid pollutants
or fumes.
EN
EN-7