AirSep Focus Manuel page 202

EN
Focus operates from four different power sources.
NOTE: Always connect to the Focus power inlet first before connecting to
a power supply.
1) Connecting Focus to AC electrical power:
When you are near an AC outlet, you may choose to operate Focus with the
universal AC/DC power supply rather than the battery.
Connect the cord on the power supply labeled as DC OUT To Focus into
the Focus unit's power inlet, as shown in Figure 7. Do not force the plug, as
it should be inserted only one way.
From the other end of the power supply, connect the 3-prong AC cord from
the power supply into any standard outlet.
DC OUT to Focus
2) Connecting Focus to a DC power source:
The universal power supply can also be used to operate the Focus unit from
any 12-Volt DC power source.
For example: to an automobile, (boat, motor home, etc.) with a 12-Volt DC
outlet.
Connect the power supply cord labeled DC OUT To Focus into the Focus
unit's power inlet, as shown in Figure 8.
Place the DC accessory adapter on the end of the DC power cord.
Connect the other end into the power supply input connection labeled
Accessory DC IN.
You can then connect the DC power cord (with adapter attached) into the
12-Volt DC power source.
Do not force the cords, as they can be inserted only one way.
EN-14
Figure 7
Focus™
Focus unit's power
inlet
®
AirSep Corporation
MN172-1 rev. A - 02/13