Optional Airbelt - AirSep Focus Manuel

EN

Optional AirBelt

Optionally, you may also have an AirBelt for extended use of Focus.
The optional AirBelt (Figure 14), can power the Focus unit for up to 4 hours.
Before using AirBelt, check that it is sufficiently charged. It requires
approximately 3 hours to completely charge.
AirBelt is equipped with a battery gauge/indicator to indicate the level of
battery charge (25-100%). To check the level of charge, press the button on
the AirBelt keypad. The battery gauge/indicator(s) illuminate to indicate the
level of battery charge (25-100%). Connect the interface cable (Figure 15)
into the AirBelt, then plug the other end of the interface cable into the
Focus, as shown in Figure 16. For proper orientation of the connector, see
Connecting to the Focus Power Inlet section.
EN-18
Figure 14: AirBelt battery
Figure 15: AirBelt to Focus cord
DC OUT To Battery
Focus™
DC OUT To Battery
®
AirSep Corporation
MN172-1 rev. A - 02/13