AirSep Focus Manuel page 196

EN
EN-8
Storing your Focus battery for extended periods of time at high
temperatures or with a fully charged/completely discharged
battery can degrade its overall battery life.
Depending upon the temperature of the Focus battery, it can
take several minutes for the charging cycle to start after
connecting to power. This is a normal condition and is intended
for safe charging. This circumstance is more likely when the
battery has been fully discharged.
The Focus battery does not need to be fully discharged before
recharging. It is recommended to charge the Focus battery after
each use.
Cannula tubing must be non-kinking, which can be used for
a total length of up to 25 ft. (7.6 m) maximum.
If the Focus power supply remains connected when the battery
is fully charged, the four LEDs will turn off within ½ hour.
Ensure the cannula is fully inserted and secure. This ensures
that the Focus unit can properly detect inspiration for oxygen
delivery.
When connected to Universal AC/DC power, the unit's battery
charges until it reaches full capacity, either while the unit is
operating or turned off.
It may be necessary to initially connect the Universal AC/DC
Focus power supply charger to the Focus Battery(s) before
the unit will operate for the first time on battery power.
Your Equipment Provider may have already performed this
step for you.
AirSep does not recommend the sterilization of this equipment.
If the Focus power supply remains connected when the battery
is fully charged, the four LEDs will turn off within 15 minutes.
Focus™
®
AirSep Corporation
MN172-1 rev. A - 02/13