Cleaning; Charging; Storage - Worx LANDROID WR165 Manuel Utilisateur

Maintenance
Attention: When fitting new blades, make sure you replace ALL the blades.
Always use new screws when fitting blades. This is important to ensure blade retention and blade turning disc balance. Failure
to use new screws could cause serious injury.
Important: After screwing the blade to the blade disc, make sure the blade is able to spin freely.

Cleaning

Your Landroid should be cleaned regularly. This helps keep it in good condition. Excess dirt, debris, and build-up of grass from daily
mowing may cause sub-optimal performance. Turn off Landroid and remove the battery before cleaning.
Attention: Make sure the battery cover is closed when rinsing off your Landroid.
WARNING! Your Landroid can only be rinsed by using a hose! DO NOT use high pressure washer on your
Landroid. High pressure water can penetrate the seals and damage electronic and mechanical parts.
1. Cleaning the top of the mower
A. Clean with a spray bottle filled with water or a hose. Do not use solvents or polishers.
B. Use a brush or a clean cloth to remove built-up dirt.
2. Cleaning the Bottom
A. Turn Landroid upside down.
B. Use a brush to remove debris and grass clippings.
C. Be careful not to touch the blades with your hands. Wear gloves for protection.
D. Clean the blade disc, the chassis and the front wheel(s) thoroughly with a soft brush or moist rag
E. Rotate the blade disc to ensure it rotates freely. Remove any obstructions to avoid damage to the blade disc.
F. Check that the blades spin freely around the fixing screws. Remove any obstructions.
3. Cleaning the drive wheels
A. Remove mud from the rear wheels with a brush in order to ensure good wheel traction.
4. Cleaning the charging contacts
A. Clean the contact paddles located on the charging station and the charging contacts located on the Landroid using a cloth
B. Periodically remove any build-up of grass clippings or debris around the contact paddles and the charging contacts to ensure
Landroid successfully charges each time.

Charging

The heart of Landroid is its 20V Li-Ion Worx Powershare Battery.
A. For the proper storage of the battery, make sure it is fully charged and kept in a cool dry place.
B. The recommended Landroid operation temperature is between 32-131°F (0-55°C).
C. The life-span of Landroid's battery depends on hours of usage and the length of use per day during the mowing season.

Storage

Although Landroid is designed and built to survive the most severe weather conditions, we recommend storing it in your shed or
garage during the winter. To prepare it for winter hibernation:
A. Clean it thoroughly.
B. Fully charge the battery.
C. Turn the power off.
EN
29