Worx LANDROID WR165 Manuel Utilisateur page 32

Quick reference
MESSAGE CAUSE
Wheels motor fault! Rear wheel is blocked
Press START to reset. in some way.
Upside down! Press This could have
START to reset. happened when
Landroid came into
contact with a
sloping surface which
made it overturn.
Mower stuck! Press Landroid is stuck.
START to reset. Also, if the rear wheels
cannot move and have
tried to course correct
several times in a short
period, or the bump
sensor has been
activated several times
in a short period, this
will cause a Stuck error.
Mower lifted! Press Landroid is lifted up.
START to reset. Also, if the lift sensor
has been activated
several times in a short
period, this will cause a
Lifted error.
Wire missing! Press Machine can't find
START to reset. boundary wire signal.
Battery temperature Temperature is too high
out of range! (more than 55
Please wait. too low(less than 0
when charging.
Can't find charge Boundary wire is
station. beyond its maximum
Press START to reset. length (984 ft.).
32
ACTION
Turn power off and take Landroid to an area free from obstacles.
Turn power on.
If the error message is still displayed, turn power off. Turn Landroid
upside-down and check if there's anything preventing the wheels from
rotating.
Remove any obstruction, if necessary, then turn the mower upright, and
power on.
Turn Landroid upright and remove any obstruction that might have caused
Landroid to overturn.
Turn power off.
Take Landroid to an area of your lawn free of obstacles, then turn power on.
If the error message is still displayed: turn power off, turn Landroid
upside-down. Check if there is anything preventing the wheels from rotating.
Remove any obstruction, turn the Landroid upright, turn power on.
Turn power off.
Take Landroid to an area clear of obstacles, turn power on.
If the error message is still displayed: turn power off, turn Landroid
upside-down and check if there is any obstruction that would prevent the
front wheel casters from sliding into the mower body. When the mower is
lifted, the casters should drop down away from the mower body. When
placed back on level ground, the casters should slide back into the body.
Remove any obstruction if necessary, then turn the mower upright, and
power on.
If the LED light is red, check if the boundary wire is well connected to the
wire terminal clamps on the charging station.
If the problem persists, check that the boundary wire hasn't been cut.
Place the charging station in a shady area or wait until it reaches the normal
C)or temperature
0
C)
0
Take Landroid to the charging station.
If the boundary wire length is beyond the rated limit, then the wire length
should be shortened.
EN