Worx LANDROID WR165 Manuel Utilisateur page 34

Quick reference
SYMPTOM
Grass is being cut
unevenly.
Your Landroid is inside
its working area and
the boundary wire is
connected, but the display
says 'Outside working area!
Press START to reset'
The charging time is
far more than the rated
charging time.
The mower does not
charge.
Landroid is starting to
have shorter run-times
between charges.
Landroid is not operating
at the correct time.
Landroid cannot correctly
dock with the charging
station.
The green light on the
charging station turns
on before charging is
complete.
34
CAUSE
Landroid does not work enough
hours per day to cut the grass.
Mowing area is too big for the
size of Landroid you have.
The blades are dull and not sharp. Change all the blades so that maximum cutting efficiency is
The cutting height is set too low
for the length of the grass.
Grass or another object has
wrapped around the blade disc.
There is a build-up of grass in the
blade disc or motor frame box.
The boundary wire ends are
clamped incorrectly.
Poor connection caused by
debris on the charging station.
The charging protection
program is activated due to high
temperature.
There is no power.
Something is lodged in the blade
disc creating friction and
increasing power consumption.
Landroid is shaking heavily
because the blade disc is
unbalanced.
The battery may be exhausted
or old.
The clock is not set to the
correct time.
the percentage of weekly
operating time set through App.
has changed.
Charging station is not level.
Poor connection caused by
debris on the charging station
paddles.
The charging station is
overheating or overcooling
SOLUTION
Try adding more hours to the mowing schedule.
Try decreasing the size of the mowing area.
achieved.
Raise the cutting height and then gradually lower.
Check the blade disc and remove any grass or other objects that
might prevent it spinning.
Make sure the blade disc rotates easily. If need be, you may take
off the blade disc and then remove the debris.
Reverse the boundary wire ends and reconnect to the charging
station.
Clean the contact paddles located on the charging station and
the charging contacts on Landroid using fine grit sand paper.
Place the charging station in a shady area or wait until the
temperature has cooled down.
Check the power cord is connected properly to the charger and
the charger is connected to a suitable power supply.
Make sure both the charging contacts on the mower touch the
center of the contact paddles on the charging station.
Take off the blade disc and clean it. Remove any foreign objects
obstructing the blade disc.
Check the blade disc and blades, remove debris and foreign
objects from the blades and blade disc. Replace the blades with
a new set.
Replace battery.
Set the clock to the correct time.
Set the correct percentage through the App.
Use a level to ensure that the charging station is on level ground.
Re-work any unlevel spots that could cause the charging station
to move while the mower drives through it.
Clean the contact paddles located on the charging station and
the charging contacts on the mower using a fine grit sand paper.
Place the charging station in a shady area or wait until it reaches
the normal temperature
EN