Quick Reference; Operation Messages; Error Messages - Worx LANDROID WR165 Manuel Utilisateur

Quick reference

OPERATION MESSAGES

MESSAGE
Cutting grass
Raining
Going home
Charging
No working time scheduled
Not working today
Work done today
Zone searching
Charge complete
Emergency charge

ERROR MESSAGES

Sometimes things can go wrong. Fortunately Landroid is smart enough to tell you if it is enountering an issue, so you can fix it. If in doubt,
please visit our website at www.worx.com/landroid-support, where you will find useful videos and further support.
MESSAGE CAUSE
Outside working area! Landroid cannot find
Press START to reset. the boundary wire
signal.
WRONG PIN! Please PIN code is wrong.
retry.
Blade motor fault! Blade disc is blocked
Press START to reset. by an object, e.g. a
branch.
Blade is over-loaded by
thick dense grass.
LANDROID ACTION
Cutting grass according to the mowing schedule.
The rain sensor detects water. Landroid will return to the charging station and stay
there until the sensor is completely dry. When the sensor is completely dry,
Landroid will automatically begin the rain delay countdown and then return to mow.
If you want Landroid to mow before the rain delay counter is finished, simply turn it
off then on again. Or you can remove the rain delay completely by setting the rain
delay time to zero.
Needs to recharge—while traveling back to the charge station, the cutting blade
does not operate in order to save energy.
'Charging' and charge percentage are displayed.
Stand-by, needs to be programmed as desired.
Stand-by, will start according to mowing schedule.
Landroid is searching a certain area to mow based on the customized work zone
parameters.
Landroid has completed its charging.
Landroid is charging in a powered-off state.
ACTION
1. If Landroid is actually outside of its working area: power off the mower, take
Landroid inside the working area, power on and press start.
2. If the associated error is displayed and the mower is inside the boundary
AND the charging station LED is green, then the wires leading into the
charging station are most likely reversed, and need to be switched.
Input the correct PIN or re-set your PIN.
Turn power off and remove battery.
Turn Landroid upside down and check if there's anything preventing the blade
disc from rotating and remove any obstruction.
Turn the mower upright, and power on.
Turn power off.
Take Landroid to an area with short grass or adjust the cutting height to a
higher setting.
Power on.
EN
31