Replace The Blades; Keep It Clean; Cleaning The Body; Cleaning The Underside - Worx LANDROID Mode D'emploi

are chipped or damaged and replace them if they are. When the cutting blades are dull and worn out, they should be
replaced with the spare blades provided with your Landroid
retailer.
A. Replace the Blades
After some time, usually every season, your Landroid
will need to be replaced. When replacing the Blades, make sure
to replace all of them at the same time. You can replace them
with one of the spare Blade kits and extra Blade screws supplied
®
with your Landroid .
Before attempting to replace your Landroid
power off and put on protective gloves and follow these steps:
1. Gently flip the Landroid
2. Remove the battery cover and remove the battery.
3. Take the screws off the Blades with a screwdriver (See Fig. M)
4. Firmly screw on the new Blades.
5. Refit the battery and the battery cover.
IMPORTANT: After screwing the Blade to the Blade
Disc, make sure the Blade is able to spin freely.

9.2 Keep it clean

WARNING: Before cleaning, turn your Landroid
OFF. Put on protective gloves before cleaning the
Blade Turning Disc (13) and do not rinse or flush with
water.
A. Cleaning the body
®
Your Landroid will live a much happier and longer life if it is
cleaned regularly. Although, since your Landroid
machine, you will need to take care when cleaning. DO NOT
use a hose, high pressure washers or otherwise pour
running water on your Landroid
bottle filled with water. When cleaning the machine body, use a
soft brush or clean cloth and avoid using solvents or polishes
(See Fig. N). Lastly, remove all build up of grass clippings and
debris.
B. Cleaning the Underside
Again, it is important that you power the Landroid
Disc (13).
®
First, flip your Landroid upside down to expose its underside. Here you will see the Blade Disc, the chassis, and the
Front Wheel (11) and Driving Wheels (6). Clean everything thoroughly with a soft brush or moist rag.
WARNING: NEVER clean the underside of Landroid
Fig. O1, O2)
Rotate the Blade Disc to ensure it rotates freely. Check the blades spin freely around the fixing screws. Remove any
obstructions.
IMPORTANT: Remove any lodged debris so that it does not cause a crack in the Blade Disc. Even the
tiniest crack can decrease your Landroid
O1
Owner's Manual of Lawn Mowing Robot EN
®
's Blades
®
's Blades, turn the
®
over.
®
is an electric
®
. It is best to use a spray
®
OFF and wear protective gloves before touching the Blade Turning
®
's mowing output.
®
. Spare blades are also available at your nearest WORX
M
®
N
®
with running water. Component damage can occur. (See
O2
15