Boundary Wire Basics; Pegging The Boundary Wire; Burying The Boundary Wire; Joining The Boundary Wire - Worx LANDROID Mode D'emploi

7.

Boundary Wire Basics

7.1 Pegging the Boundary Wire

Use the Boundary Wire Distance Gauge (20) to set the correct
distance between the wire and the border of your lawn (more than
26cm*).
* This is the recommended distance. The provided distance gauge
ensures proper installation.
If your neighbor also uses a Landroid
metres between your Boundary Wire and your neighbors.
The Boundary Wire must outline the intended mowing
area exactly. Your Landroid
or coils of Boundary Wire that are not part of its mowing area
(See Fig. I). If there is excess Boundary Wire after the mowing
area has been outlined, cut it off and store this additional wire in
a separate location. It is important to leave the necessary length where it connects to the Charging Base so it can be
connected and still remain buried.

7.2 Burying the Boundary Wire

If you are planning to bury the Boundary Wire, it is recommended to first peg it down. This allows you to easily change the layout
if necessary before burying the wire. When the boundary wire installation is complete, have Landroid
by pressing and . This will allow Landroid
®
While observing Landroid you can easily make alterations to the boundary wire to ensure the Landroid
when locating the charging station. Confirm that Landroid

7.3 Joining the boundary wire

If you want to extend and splice the boundary wire, use a connector.
The connector is waterproof and provides optimal connection.
Insert both wire ends in any two of the three holes of the connector.
Insert the wires fully until both wire ends are visible on the other side
of the connector. (See Fig. J1) Press the connector together by using
a pair of pliers. (See Fig. J2, J3)
WARNING! It is not recommended to simply splice the
boundary wire with insulating tape or use a screw terminal
block for connection. A broken circuit may occur after a period of
time as soil moisture can oxidize the wire.
J2
Owner's Manual of Lawn Mowing Robot EN
®
, keep a spacing of at least 1
®
will become confused by extra bends
®
to adjust to its new environment.
®
docks in the charging station successfully, and bury the wire if desired.
I
®
follow and check the path
J1
J3
®
's trouble-free tracking
13