Troubleshooting - Worx LANDROID Mode D'emploi

Landroid
Blue light flashing
twice per cycle
Landroid
down.
Blue light flashing
three times per
cycle
NOTES
• Before turning power on, always return Landroid
message is also displayed when Landroid
• If for any reason—i.e. a party, children playing...—you want to park your Landroid
®
. Landroid will go to its charging base and stay there. Landroid
If you want to re-start it, press
• If an error repeatedly occurs in the same area of your lawn, you might have a problem with the boundary wire. Please
refer to the previous installation instructions and check your set up with its help.
• If your lawn is divided in two separate areas connected by a corridor less than 1m, one of which is not provided with
the Charging Base: when Landroid
the main switch (8) to "I"(on), press
®
• If Landroid runs abnormally once in a while, please try to restart it. If the problem is not resolved, try to removing and
reinstalling the battery. If the problem is still not resolved, please contact a WORX.
• Do not wash the machine with a high pressure washer. This could cause damage to the battery or the machine.

13. Troubleshooting

®
If your Landroid does not work correctly, follow the troubleshooting guide below. If the issue persists, contact your Dealer.
Symptom
®
Landroid turns on, but the Blade
Disc does not move.
®
Landroid vibrates.
Grass is being cut unevenly.
Owner's Manual of Lawn Mowing Robot EN
1. Turn Landroid
2. Take Landroid
until the battery indication light stays green. (If Landroid
®
is lifted up. capacity, the battery indication light will stay red.) Press
3. If the error message is still displayed: turn Landroid
upside-down and check there's nothing lifted up.
4. Remove any possible object, turn Landroid
®
is upside
Turn Landroid
®
to its territory. If not, the error indication light will flash red. This
®
is sitting over the boundary wire when turned on.
and to start mowing.
®
runs out of charge, take it manually to the Charging Base, turn power on by turning
and , the charge process will start.
Cause
®
Landroid is searching for the Charging
Base (unless you press the HOME
button to make it go to the charging
base, or the "Enable boundary cut"
function is operating).
Blades may be damaged. Check
condition of the Blade Disc.
®
Landroid does not work enough hours
per day.
Mowing area is too big.
Blades are dull.
The cutting height is too low for the
length of the grass.
Grass or other object has wrapped
around the blade disc.
There is a build-up of grass in the Blade
Disc or Motor Frame Box.
®
off.
®
to a lawn area clear of obstacles, turn Landroid
®
upright.
®
in the Charging Base: press
®
will wait until the next scheduled mowing session.
Action
This is normal. Landroid
the Blade Disc does not rotate while it is
searching for the Charging Base automatically.
Check the Blades, and replace them if damaged.
Remove debris and foreign objects from the
blades and blade disc.
Add more hours to the scheduled mowing
time.
Try decreasing the size of the mowing area or
adding more hours to the mowing time.
Change all the Blades and screws in order to
balance the Bade Disc.
Raise the cutting height and then gradually
lower.
Check the Blade Disc and remove the grass
or other object.
Make sure the Blade Disc rotates easily. If
need be, you may take off the Blade Disc and
remove the debris.
®
on. Wait
®
has low battery
.
® ®
off, turn Landroid
® ®
upright, turn Landroid on.
and
®
needs to recharge,
19