Control Panel; Intended Use - Worx LANDROID Mode D'emploi

3.

Control panel

Battery indication light
Displays battery/machine
status
START
Starts mowing/Corrects
the problem
Start
8
1) After the boundary wire installation, you can start using the Landroid
wire installation).
2) Turn the main switch (8) to "I"(on). Wait until the battery indication light stays green. (If Landroid
capacity, the battery indication light will stay red.) If the battery is too low, it will not stay red but shut-down to prevent
battery damage (please refer to Battery Life for emergency charge).
3) Press , then press
4) Press and
®
Landroid will work continuously until reaching low battery power level and then it will return to the charging base. Once
charging is complete, Landroid
schedule.
4.

Intended Use

The garden product is intended for domestic lawn mowing. It is designed to mow often, maintaining a healthier and better
looking lawn than ever before. Depending on the size of your lawn, Landroid
or frequency (Please check Technical Data & Declaration of Conformity for information specific to each model). It is not
intended for digging, sweeping or snow cleaning.
Owner's Manual of Lawn Mowing Robot EN
to start mowing.
®
to make Landroid go to the charging base.
®
will automatically resume mowing or it stay in the charging base according to mowing
Error indication light
Displays error messages
HOME
Sends Landroid
charging base during
operation and activates
charging
OK
Confirms any setting/
Enters Wi-Fi connection
mode
STOP
Stops Landroid
operation
®
(Please refer to Installation guide for boundary
®
®
may be programmed to operate at any time
®
to its
®
during
has low battery