How Does My Landroid; Finding The Charging Base; Rain Sensors; Sensing The Boundary Wire - Worx LANDROID Mode D'emploi

5.2 How does my Landroid

®
Your Landroid is capable of doing things on its own. The Landroid
charge, can sense when it is raining, can stop itself if it senses a problem, and knows to stop, draw back, and turn around
when it bumps into something blocking its path. The Landroid
rotating if it is lifted off the ground to prevent an accident.
A. Finding the charging base
When your Landroid
direction back to its Charging Base. Landroid
By default, Landroid
If you don't want to enable boundary cut, deactivate it via your smartphone. (Please check Technical Data & Declaration of
Conformity for information specific to each model)
B. Rain sensors
®
The Landroid is equipped with a Rain Sensor (7) which detects rain
and tells the Landroid
back to its Charging Base (See Fig. B).
®
Landroid will resume mowing after passing the Delay Time, The
default Delay Time is 180mins. Delay Time setting can be changed via
®
Landroid APP (for specific models only). Please check Technical Data
& Declaration of Conformity for information specific to each model.
When the rain sensors are wet, the Landroid
base. The error indication light will flash blue four times per cycle.
When the rain sensors dry, Landroid
countdown or return to mowing (depending on the saved settings).
If you want to exit from the rain delay, dry the sensor area, and
perform a power cycle by operating the Main Switch. After the
power cycle has been performed you can see that the blue led is not
flashing and so you can operate again.
NOTE: If the delay time is set to 0, Landroid
10
C. Sensing the boundary wire
®
The Landroid always obeys the border set by the Boundary Wire and uses sensors at its front to detect it. (See Fig. C).
C
D. Starting and stopping while mowing (See Fig. D, E1, E2)
If you would like Landroid
the main switch to "I" (on), wait until the battery indication light stays green. Press
low battery capacity, the battery indication light will stay red.)
®
If Landroid senses something is wrong, the error indication light will indicate the fault message. For information on these messages,
refer to the Error Messages." Landroid
To resume:
• Turn the Main switch (8) to "O"(off)
• Correct the problem (refer to Error Messages)
• Turn the main switch (8) to "I"(on), Wait until the battery indication light stays green. (If Landroid
capacity, the battery indication light will stay red.)
• Press , then press
• Now the Landroid
Owner's Manual of Lawn Mowing Robot EN
®
needs to recharge, it will stop mowing and follow the Boundary Wire (17) in an anti-clockwise
®
is pre-programmed to mow the grass near the boundary wire once a week.
®
will mow near the boundary wire at a random time during the next week after it is powered on.
®
to stop mowing and follow the Boundary Wire
®
returns to its charging
®
will begin the Delay Time
®
will continue mowing.
®
to stop mowing, simply press the STOP button (9) on top of the mower. To start mowing, turn
®
will turn off if it does not receive any input from the user within 20 min.
®
will begin to mow!
®
know what to mow?
®
knows when it needs to go to its Charging Base (3) to
®
will also automatically stop its Blade Turning Disc (13) from
B
D D
, then press . ( If Landroid
®
has low battery
®
has