Worx LANDROID Mode D'emploi page 20

®
Your Landroid is inside its
territory and the boundary wire
is connected. The error indication
light flashes red.
The charging time is far more
than 2h.
The mower does not charge.
®
Landroid is starting to have
shorter run-times between
charges.
®
Landroid is not operating at the
correct time.
®
Landroid cannot correctly dock
with the Charging Base
20
The Green light on the Charging
Base turns ON before charging
is complete.
®
Landroid runs outside the
boundary wire. Landroid
not mow an area within a
boundary wire zone. Landroid
reverses or rotates erratically
near the boundary wire.
®
Landroid wheels skid or
damage lawn.
®
Landroid exits the boundary
wire due to high speed when
going down a hill.
Owner's Manual of Lawn Mowing Robot EN
The boundary wire ends are clamped
incorrectly.
Poor connection caused by debris on
the Charging Strip.
The charging protection program has
activated due to high temperature.
There is no power.
Does not operate correctly while
manually charging.
Something is clogging in the Blade
Disc.
®
Landroid is shaking heavily.
The battery may be exhausted or old.
The clock is not set to the correct
time.
Programmed cutting times for
®
Landroid are not correct.
Environmental influences
Poor connection caused by debris on
the Charging Strip.
The charging base is overheating, the
battery indication light flashes red.
The boundary wire of another
®
Landroid or another robotic mower is
positioned too closely.
The boundary wire has been installed
with tight corners.
®
does
In wet conditions, the boundary wire
®
electric signal may leak where wire
has been joined or repaired.
There is boundary wire electric signal
leakage due to broken insulation.
The cutting area is larger than the
allowable cutting area for Landroid
Foreign obstacles, such as twigs
and branches may be lodged under
®
Landroid .
The lawn is too wet.
The Boundary Wire is placed on a
slope steeper than 17% (10°).
Reverse the boundary wire ends.
Clean the Contact Pins located on the
Charging Base and the Charging Strip on
®
Landroid using a cloth.
Place the charging base in a shady area or
wait until the temperature has cooled down.
Check the power cord is connected properly
to the charger and the charger is connected
to a suitable power supply.
Refer to manual charging.
Take off the Blade Disc and clean it
The grass is too high and too thick.
Check the Blade Disc and blades, remove
debris and foreign objects from the blades
and Blade Disc.
Replace battery.
Set the clock to the correct time by using
App.
Change the time settings for the mower to
start and stop.
®
Restart Landroid .
Clean the Contact Pins located on the
Charging Base and the Charging Strip on
®
Landroid using a cloth.
Place the charging base in a shady area or
wait until the temperature has cooled down.
Ensure your Landroid
least 1m of space between the neighboring
boundary wire.
Check the boundary wire to ensure the
corners are smooth.
Check boundary wire joints. Insulate to
provide a fully waterproof connection.
Repair damaged boundary wire insulation
with connectors.
Contact service agent.
®
.
Remove foreign objects from underside of
®
Landroid .
Wait until lawn has dried.
Reposition the Boundary Wire away from
slopes that are steeper than 17% (10°).
Please refer installation manual for details.
®
Boundary Wire has at