Turn On And Test Installation; Maintenance; Keep It Sharp; Rotate And Flip The Blades - Worx LANDROID WG794E Manuel D'instructions

4.4 Turn on and test installation

If the charger light does not come on, then check the power connections.
If the charger base LED is flashing green, check if the boundary wire is connected correctly.
Red light on: charging.
Red light flashing: error message, refer to Trouble Shooting and correct the problems.
Green light flashing: check if the boundary wire is connected correctly.
When the green light on the charging base is on, place your Landroid
boundary it is connected correctly.
If your Landroid
base LED is green, it means you clamped the boundary wire ends incorrectly. Just reverse them.
5.

Maintenance

®
Your Landroid M needs to be checked from time to time. The Landroid
as well as having some parts replaced, as they can become worn.
In the following we want to let you know how to take care of your Landroid

5.1 Keep it sharp

WARNING: Before cleaning, adjusting, or replacing the Blades, turn your Landroid
pressing the ON/OFF Button to OFF and put on protective gloves.
WARNING: When fitting new blades, make sure you replace ALL the blades. Always use new
screws when fitting blades . This is important to ensure blade retention. Failure to use new
screws could cause serious injury.
®
The Landroid M does not cut grass like other mowers. Its Cutting
14
Blades (14) are razor sharp on all 4 edges and spin in both directions
for maximum cutting capacity (See Fig. J ).Each blade of your
®
Landroid M has 4 cutting edges. Depending on the frequency
®
the Landroid M mows your lawn, the cutting blades will need
to be flipped/rotated periodically for a new cutting edge. If your
®
Landroid M is programmed to mow the lawn every day then
the cutting blades will need to be rotated monthly for the best
mowing results. Each cutting blade will last up to 4 months when
it is programmed to mow every day. When the cutting blades are
dull and worn out, they should be replaced with the spare blades
provided with your Landroid
your nearest WORX retailer.
A. Rotate and flip the blades
®
Your Landroid M carries 3 Blades that are all screwed onto your its Blade Turning Disc (13). The Blades are what let the
®
Landroid M do its job and need care and attention. Every once in awhile, you should simultaneously rotate and flip all
3 blades for a perfect cut. When rotating and flipping the Blades,
make sure all the Blades are adjusted at the same time or else it
could make the Blade Disc off balance. If your Landroid
on a normal schedule (daily) then the Blades should last one season
if they are rotated and flipped every month. Always check to see if
the Blades are chipped or damaged and replace them if they are.
B. Replace the blades
After some time, usually every season, your Landroid
will need to be replaced. Your Landroid
while using Blades of different age and quality. So when replacing
the Blades, make sure to replace all of them at the same time. You
can replace them with one of the three spare Blade kits and extra
Blade screws supplied with your Landroid
Lawn Mowing Robot
®
M is inside its territory but the display says "out of cutting area" ,and the charger
®
M. Spare blades are also available at
®
M does not like mowing
®
M.
®
M over the boundary wire, if Landroid
®
M works hard and after time needs a good cleaning
®
M.
J
®
M mows
®
M's Blades
K
®
M follows the
® M OFF by
1 2
3 4
EN