Battery Life; Winter Hibernation; Replacing The Battery - Worx LANDROID WG794E Manuel D'instructions

Masquer les pouces Voir aussi pour LANDROID WG794E:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 36

5.3 Battery life

The heart of the Landroid
maintenance is required. For proper storage of the battery, make
sure it is fully charged in kept in a cool dry place between (20°C-60°C).
The life-span of the Landroid
factors, such as:
The time span of the mowing season in your region
Amount of hours the Landroid
Battery maintenance during storage
®
Landroid
M can be charged manually without the
boundary wire
(See Fig. N).
To manually charge the battery without connecting the
boundary wire to the charging base;
1. Connect the Charging Base to a suitable power supply.
2. Manually dock the Landroid
3. The charging base red light will turn on.
4. Within 3 seconds and before the charging base light turns green, press the Landroid power ON/
OFF button.
5. Landroid will begin to charge.

5.4 Winter hibernation

®
Your Landroid
M will live longer and healthier if it is allowed to hibernate. So even though it is tough, we would recommend
that you store your Landroid
Before you prepare your Landroid
recommend you:
16
Thoroughly clean your Landroid
Fully charge the battery
Turn the power off
To maximize the battery life, it is recommended to fully charge the
battery before storage during winter.
The Boundary Wire can be left in the ground although its ends should
be protected, such as placed in a tin can with grease. If the Charging
Base is left outside for winter, leave the Boundary Wire connected.
NOTE: Before storing for winter, you can take your Landroid
a dealer for a thorough cleaning and tune-up, where its functions will
be tested and worn parts will be replaced.
When bringing the Landroid
make sure the Charging Strips (5) and Contact Pins (3) are clean, it is
recommended to use a fine grade emery cloth to clean. Then make
sure the date and time are correct and send the Landroid
what it loves doing: mowing.

5.5 Replacing the battery

WARNING: Press the ON/OFF Key to OFF before
attempting any adjustment, replacement or repair.
If you need to replace the Battery, follow these steps:
1.
Gently turn your Landroid
2.
Remove the four screws on the battery cover (See Fig. O).
3.
Take out the old battery (See Fig. P).
4.
Put in the new battery.
5.
Firmly replace the 4 screws.
Lawn Mowing Robot
®
M is its 28-volt lithium-ion battery. No
®
M's battery depends on various
®
M mows per day
®
M into the Charging Base while the Landroid
®
M in your shed or garage during the winter.
®
M for winter hibernation, we
®
M
®
M back to work after winter hibernation,
®
M upside down.
1
N
®
M to
O
®
M back to
P
®
M is powered off.
EN

Publicité

Table des Matières
loading

Table des Matières