Keep It Clean; Cleaning The Body - Worx LANDROID WG794E Mode D'emploi

To maximize the battery's life, it is recommended to fully charge the
battery before storage during winter. To only charge the battery you:
• Connect the Boundary Wire (21) to the Charging Base (4).
• Connect the Charging Base to a power source.
• Place the Landroid
• Press the On/Off Key. (See Fig. J)
• Then press the Home Key. (See Fig. K)
• Close the Control Panel Cover. (See Fig. L)
• Allow the Landroid
The Boundary Wire can be left in the ground although its ends
should be protected, such as placed in a tin can with grease. If the
Charging Base is left outside for winter, leave the Boundary Wire
connected.
NOTE: Before storing for winter, you can take your Landroid
functions will be tested and worn parts will be replaced.
When bringing the Landroid
are clean, it is recommended to use a fine grade emery cloth to clean. Then make sure the date and time are correct and
®
send the Landroid

5.3 Keep it clean

WARNING: Before cleaning turn your Landroid
protective gloves before cleaning the Blade Turning Disc (13) and do not use running water.
(See Fig. M,N)
A. Cleaning the body
®
Your Landroid M will live a much happier and longer life if it is cleaned regularly. Although, as your Landroid
14
electric machine, you will need to take care when cleaning, so
DO NOT use a hose or otherwise pour running water on your
®
Landroid M, it is best to use a spray bottle filled with water. When
cleaning the machine body use a soft brush or clean cloth and avoid
using solvents or polishes (See Fig.M) .Lastly, make sure that you
remove all build up of grass clippings and debris.
B. Cleaning the Underside
Again, it is important that you power the Landroid
ON/Off Button and wear protective gloves before touching
the Blade Turning Disc (13).
First, flip your Landroid
Here you will see the Blade Disc (a), the chassis (b), and the Front
Wheel (15) and Driving Wheel(10). Clean everything thoroughly with
a soft brush or moist rag.(See Fig.N)
M
Lawn Mowing Robot
®
M in the Charging Base.
®
M to charge for at least 1.5 hrs.
®
M back to work after winter hibernation, make sure the Charging Strips (5) and Contact Pins (3)
M back to what it loves doing: mowing.
®
M upside down to expose its underside.
L
®
M to a dealer for a thorough cleaning and tune-up, where its
®
M OFF by pressing the ON/OFF Button. Put on
(a)
®
M OFF using the
N
®
M is an
(b)
EN