How Does My Landroid M Know Where To Go; Finding The Charging Base; Rain Sensors; Sensing The Boundary Wire - Worx LANDROID WG794E Mode D'emploi

3.2 How does my Landroid
know where to go?
®
Your Landroid M is capable of doing things on its own. The
®
Landroid M knows when it needs to go to its Charging Base (4) to
charge, can sense when it is raining, can stop itself if it senses a
problem, and knows to stop and turn around when it bumps into
something blocking its path, such as a person, pet, or other object.
®
The Landroid M will also automatically stop its Blade Turning Disc (13)
from rotating if it is lifted off the ground to prevent an accident.
A. Finding the charging base
When your Landroid
follow the Boundary Wire (21) in an anti-clockwise motion back to
its Charging Base. To save energy, the Landroid
rotate its Blade Turning Disc when returning to its Charging Base.
B. Rain sensors
®
The Landroid M has a Rain Sensor (9) at its side that will sense
rain drops and tell the Landroid
Boundary Wire back to its Charging Base (See Fig. B).
®
The Landroid M is programmable to have a delay start function
(0 – 180 mins) when it rains. When the rain sensors are wet, the
®
Landroid M returns to its docking station. Only when the rain
sensors become dry will the Landroid
countdown or return to mowing immediately. See the Programming
and Troubleshooting Guide for more details.
C. Sensing the boundary wire
®
The Landroid M always obeys the border set by the Boundary
Wire and uses two sensors at its front to sense when it is getting
10
close(See Fig. C). Before changing direction, the Landroid
*This is the recommended distance. Use the provided distance gauge to ensure proper installation.
D. Starting and stopping while mowing
If you would like to command the Landroid
To start mowing, press the ON/OFF key, press start key directly or open the Control Panel Cover and input your further
commands, at last press START key (See Fig. D,E).
D
Lawn Mowing Robot
®
M needs to recharge, it will stop mowing and
®
®
M to stop mowing and follow the
®
M begin the delay start
®
M to stop mowing, then simply press the STOP button (8) on top of the mower.
®
M
B
M chooses not to
C
®
M will overrun the Boundary Wire up to 20cm*.
E
1
2
EN