How Does My Landroid L Know Where To Go; Finding The Charging Base; Rain Sensors; Sensing The Boundary Wire - Worx Landroid L WG792E.1 Mode D'emploi

3.2 How does my Landroid
where to go?
®
Your Landroid L is capable of doing things on its own. The Landroid
knows when it needs to go to its Charging Base (3) to charge, can
sense when it is raining, can stop itself if it senses a problem, and
knows to stop, drawback, and then turn around when it bumps into
something blocking its path or other object. The Landroid
automatically stop its Blade Turning Disc (16) from rotating if it is
lifted off the ground to prevent an accident.
A. Finding the Charging Base
®
When your Landroid L needs to recharge, it will stop mowing and
follow the Boundary Wire (23) in an anti-clockwise direction back to its
Charging Base. Landroid
the boundary wire once a week.
If you want to mow the grass near the boundary wire at other times,
open the keypad window, press the home button and close the keypad
®
window. Landroid L will stop mowing, locate the boundary wire and
mow the grass near the boundary wire while it locates the charging
station. We suggest you use this function when the battery power is
more than 75%. You can check the battery power in the display.
B. Rain sensors
®
The Landroid L is fitted with a Rain Sensor (12) that will detect
rain drops and tell the Landroid
Boundary Wire back to its Charging Base. (See Fig. B)
®
The Landroid L is programmable to have a delay start function
(0 – 180 mins) when it rains. When the rain sensors are wet, the
®
Landroid L returns to its docking station. Only when the rain sensors
become dry will the Landroid
return to mowing immediately. See the Programming and Troubleshooting Guide for more details.
C. Sensing the boundary wire
®
The Landroid L always obeys the border set by the Boundary Wire and uses two sensors at its front to sense when it is
getting close (See Fig. C). Before changing direction, the Landroid
*This is the recommended distance. Use the provided distance gauge to ensure proper installation.
D. Starting and stopping while mowing
If you would like to command the Landroid
It will not begin mowing again until you have press
®
If the Landroid L senses that something is wrong, it will display a fault message on the Display (20), and will turn itself off if
it does not receive any input from the user within 20 min (for information on fault messages refer to the Programming and
Troubleshooting Guide).
D
Lawn Mowing Robot
®
®
L is pre-programmed to mow the grass near
®
L to stop mowing and follow the
®
L begin the delay start countdown or
®
L to stop mowing, then simply press the STOP button (8) on top of the mower.
L know
®
L
®
L will also
B
C
®
L will overrun the Boundary Wire up to 25cm*.
and closed its Keypad Window. (See Fig. D, E)
E
9
EN