How Does My Landroid M Know Where To Go; Finding The Charging Base; Rain Sensors; Sensing The Boundary Wire - Worx LANDROID WG796E Mode D'emploi

3.2 How does my Landroid
know where to go?
®
Your Landroid M is capable of doing things on its own. The
®
Landroid M knows when it needs to go to its Charging Base (4)
to charge, can sense when it is raining, can stop itself if it senses
a problem, and knows to stop, draw back, and then turn around
when it bumps into something blocking its path or other object. The
®
Landroid M will also automatically stop its Blade Turning Disc (13)
from rotating if it is lifted off the ground to prevent an accident.
A. Finding the charging base
®
When your Landroid M needs to recharge, it will stop mowing and
follow the Boundary Wire (21) in an anti-clockwise direction back
to its Charging Base. Landroid
grass near the boundary wire once a week. If you want to mow the
grass near the boundary wire at other times, open the panel cover,
press the home button and close the panel cover. Landroid
stop mowing, locate the boundary wire and mow the grass near the
boundary wire while it locates the charging station . We suggest you
use this function when the battery power is more than 75%. You can
check the battery power in the display.
B. Rain sensors
®
The Landroid M is fitted with a Rain Sensor (9) that will detect
rain drops and tell the Landroid
Boundary Wire back to its Charging Base (See Fig. B )
®
The Landroid M is programmable to have a delay start function
(0 – 180 mins) when it rains. When the rain sensors are wet, the
®
Landroid M returns to its docking station. Only when the rain sensors
become dry will the Landroid
return to mowing immediately. See the Programming and Troubleshooting Guide for more details.
C. Sensing the boundary wire
®
The Landroid M always obeys the border set by the Boundary Wire and uses two sensors at its front to sense when it is
getting close(See Fig. C). Before changing direction, the Landroid
*This is the recommended distance. Use the provided distance gauge to ensure proper installation.
D. Starting and stopping while mowing (See Fig. D,E)
If you would like to command the Landroid
To start mowing open the Control Panel Cover, press the ON/OFF key and input the PIN code, then press start key and
close the panel cover.
D D
Lawn Mowing Robot
®
M
®
M is pre-programmed to mow the
®
M to stop mowing and follow the
®
M begin the delay start countdown or
®
M to stop mowing, then simply press the STOP button (8) on top of the mower.
B
®
M will
C
®
M will overrun the Boundary Wire up to 20 cm*.
E
9
EN