Software Update; Maintenance; Keep It Sharp - Worx LANDROID WG796E Mode D'emploi

6.

Software update

®
Your Landroid M software can be updated when new versions
become available. The software version will be showed in the display.
The manual in box is based on the default software in the mass
production. Some new features/functions in the new version may not
exist in the manual. If you found some settings not in the manual,
please visit www.worxlandroid.com. to download the latest manual.
You can check the software version installed on your machine by
pressing the ON/OFF button.
The latest software can be downloaded from our website – see
below download and installation instructions;
Step 1: Locate the latest software version at : www.worxlandroid.com.
Copy the " .bin" file containing the latest software version to a USB
memory stick.
NOTE: Before transferring the "bin" file make sure the
memory stick does not contain other files or data.
Step 2: Open the cover at the bottom and remove the battery and
then insert the U disk to the USB port. (See Fig. J1)
Step 3: Insert the battery pack and press the ON/OFF button for ten
seconds until the mower is powered ON. The new software version will
be displayed in the bottom right corner of the display. (See Fig. J2)
Step 4: Remove the memory stick and refit the battery cover.
Step 5: After installing the new software you will need to reset the
diagnostic panel on your mower. Firstly, position the mower on a
horizontal surface.
Press Key "2" to enter the diagnosis interface, then press key "5"
for a few seconds until the three numbers 1 2 & 3 highlighted below
turn back to zero.( See Fig. J3)
12 7.

Maintenance

®
Your Landroid M needs to be checked from time to time. The
®
Landroid M works hard and after time needs a good cleaning as well
as having some parts replaced, as they can become worn.
In the following we want to let you know how to take care of your
®
Landroid M.

7.1 Keep it sharp

WARNING: Before cleaning, adjusting, or replacing
the Blades, turn your Landroid
the ON/OFF Button to OFF and put on protective gloves.
WARNING: When fitting new blades, make sure
you replace ALL the blades. Always use new
screws when fitting blades. This is important to ensure
blade retention. Failure to use new screws could cause
serious injury.
®
The Landroid M does not cut grass like other mowers. Its
Cutting Blades (14) are razor sharp on all 4 edges and spin in
both directions for maximum cutting capacity (See Fig. K ).Each
blade of your Landroid
frequency the Landroid
need to be flipped/rotated periodically for a new cutting edge. If
®
your Landroid M is programmed to mow the lawn every day then
the cutting blades will need to be rotated monthly for the best
mowing results. Each cutting blade will last up to 4 months when
it is programmed to mow every day. When the cutting blades are
dull and worn out, they should be replaced with the spare blades
Lawn Mowing Robot
®
M OFF by pressing
®
M has 4 cutting edges. Depending on the
®
M mows your lawn, the cutting blades will
J1
J2
1
2
3
J3
1
3
K
2
4
EN