Software Update; Maintenance; Keep It Sharp - Worx LANDROID M WR140 Mode D'emploi

5.

Software Update

®
Your Landroid M software can be updated when new versions
become available. You can check the software version installed on
your machine by pushing the ON/OFF button. The software version
will be displayed in the bottom right hand corner of the display.
(See Fig J1, J2, J3)
The latest software can be downloaded from our website – see
below download and installation instructions;
Step 1: Locate the latest software version at : www.worxlandroid.com.
Copy the " .bin" file containing the latest software version to a
USB memory stick.
NOTE: Before transferring the "bin" file make sure the
memory stick does not contain other files or data.
Step 2: Remove the battery cover and insert the memory stick
into the USB port .
Step 3: Press the ON/OFF button for ten seconds until the
mower is powered ON. The new software version will be
displayed in the bottom right corner of the display.
Step 4: Remove the memory stick and refit the battery cover.
Step 5: After installing the new software you will need to reset
the diagnostic panel on your mower. Firstly, position the mower
on a horizontal surface.
Press Key "2" to enter the diagnosis interface, then press key "5"
for a few seconds until the three numbers 1 2 & 3 highlighted
below turn back to zero.
6.

Maintenance

®
Your Landroid M needs to be checked from time to time. The
14
®
Landroid M works hard and after time needs a good cleaning as
well as having some parts replaced, as they can become worn.
In the following we want to let you know how to take care of your
®
Landroid M.

6.1 Keep It Sharp

WARNING: Before cleaning, adjusting, or
replacing the Blades, turn your Landroid
by pressing the ON/OFF Button to OFF and put on
protective gloves.
WARNING: When fitting new blades, make sure
you replace ALL the blades. Always use new
screws when fitting blades . This is important to
ensure blade retention. Failure to use new screws could
cause serious injury.
®
The Landroid M does not cut grass like other mowers. Its
Cutting Blades (14) are razor sharp on all 4 edges and spin in
both directions for maximum cutting capacity (See Fig. K). Each
blade of your Landroid
frequency the Landroid
need to be flipped/rotated periodically for a new cutting edge. If
®
your Landroid M is programmed to mow the lawn every day then
the cutting blades will need to be rotated monthly for the best
mowing results. Each cutting blade will last up to 4 months when
it is programmed to mow every day. When the cutting blades are
dull and worn out, they should be replaced with the spare blades
Lawn Mowing Robot
®
M has 4 cutting edges. Depending on the
®
M mows your lawn, the cutting blades will
J1
J2
1
2
® M OFF
J3
K
3
1 2
3 4
EN