Cleaning And Storage - Kiwi KMC 6940 Mode D'emploi

Multifunción thermo cocinar
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4. Place the ingredient to be weighed onto the scale. The weight is displayed.
5. If the
button is pressed and held for approx. 3 seconds, the tare function (Tare) is
activated and the weight displayed is reset to 0. Additional ingredients can now be
placed on the scale to be weighed.

Cleaning and Storage

ATTENTION!
• Caution: Risk of burns! Allow the device to cool down completely before cleaning it.
• Danger of electric shock from water! Remove the mains plug from the plug socket
before cleaning the device.
• Risk of damage to the device! Do not immerse the mixing bowl in water or other
liquids. No liquid must get into the bottom section of the mixing bowl as this is where
heating elements and other electronic components are fitted. The mixing bowl must
not be cleaned in the dishwasher.
• The device and all its accessories are not dishwasher-safe!
• Clean the mixing bowl and the accessories immediately after each use to prevent
germ formation. Do not allow food residues to dry on.
• Do not use any corrosive or abrasive cleaning agents or scouring sponges to clean the
device. These can damage the surface.
If the mixing bowl and cross-blade attachment are only slightly dirty, it is
sufficient to clean them briefly using water:
• pour 1 litre of water and a few drops of washing-up liquid into the
mixing bowl,
• close the mixing bowl with the mixing bowl lid,
• press the PULSE button a few times,
• rinse out the mixing bowl thoroughly with clear water.
1. Rinse out the mixing bowl briefly under running water.
2. Remove the cross-blade attachment from the mixing bowl (see "Using Accessories
Correctly" | "Cross-Blade Attachment").
3. Clean all components apart from the motor unit thoroughly using mild detergent
and warm water. If necessary, remove the sealing rings for cleaning.
4. Wipe down the motor unit with a slightly damp cloth if necessary and then dry it
with a soft cloth.
5. Allow all parts to dry completely before the device is reassembled. Reattach all
sealing rings.
6. Store the device in a dry, clean place that is not accessible to children and animals.
The plastic parts may suffer discolouration over time. However, this does not
have any negative effect on either health or the way that the device parts
work.
43
KMC 6940 User Manual

Publicité

Table des Matières
loading

Table des Matières