Kiwi KMC 6940 Mode D'emploi page 34

5. Check that the cross-blade attachment fits securely.
Removing:
Follow the steps for inserting in reverse order:
1. Hold the cross-blade attachment at the top end with one hand.
2. Turn the mixing bowl upside down, loosen the wing nut anticlockwise and remove it.
3. Take the cross-blade attachment out of the mixing bowl.
Blade Guard

The blade guard prevents the food being chopped up while it is being stirred.
•The blade guard is placed onto the cross-blade attachment. To do this, hold the end of
the shank of the cross-blade attachment on the bottom of the mixing bowl.
•To remove the blade guard again, twist it back and forth slightly and pull it up and off
at the same time.
Stirring Attachment (Butterfly)

ATTENTION!
• Risk of damage to the stirring attachment! Do not add any food which could
damage or block the stirring attachment while the device is operating.
The stirring attachment is suitable for whipping cream or beating egg white and for
stirring soups, puddings, sauces, rice pudding etc.
4. Twist the wing nut clockwise as far as it will go
34
• The stirring attachment is
plugged onto the cross-blade
attachment with the wings
pointing downwards. It must
engage!
• To remove it again, twist it
back and forth slightly and
pull it up and off at the same
time.