Kiwi KMC 6940 Mode D'emploi page 35

Mixing Bowl

The mixing bowl is where the items to be mixed or cooked are processed and heated.
The markings in the mixing bowl show the minimum and maximum fill levels.
The minimum fill level of the mixing bowl is 0.5 litres.
The maximum fill level of the mixing bowl is 1.5 litres. Do not exceed this!
There is a danger of scalding from hot items that are being mixed splashing out.
Moreover, the mixing bowl could overflow during operation.
Inserting mixing bowl into the motor unit:
• Place the mixing bowl into the mixing bowl mount on the motor unit.
• Apply gentle pressure to push down the mixing bowl until you hear it engage in place.
Removing mixing bowl from the motor unit:
Lid of Mixing Bowl

The mixing bowl lid closes the mixing bowl. To ensure that the items being mixed or
cooked do not splash out, the device can only be operated if the lid has been attached
and locked in place properly.
Attaching:
ATTENTION!
 Caution: Risk of scalding from hot items that are being mixed splashing out!
Before inserting the mixing bowl lid, ensure that the sealing ring has been fitted
correctly, is clean and undamaged so that the lid is tight and neither liquids nor
ingredients can splash out between the mixing bowl and mixing bowl lid. If the sealing
ring is damaged, replace it immediately and always do so after no more than 2 years in
each case.
The sealing ring must be fitted in the groove at the edge of the lid. If this is not the case,
insert the sealing ring.
1. Insert the mixing bowl lid into the mixing bowl so that the lid handle is located on
the right next to the handle of the mixing bowl.
Press the release button, at the same time tilt the mixing
bowl slightly towards you by pulling on the handle, and pull the
mixing bowl out of the motor unit.
35
KMC 6940 User Manual