Checchi & Magli BABY TRIUM Manuel D'utilisation Et D'entretien page 76

Adjusting the flexible plate centring
A
UN41-0710EO
For this operation, proceed as outlined below.
1) Loosen the screws (A).
2) Centre the flexible plate (B) in relation to the share
(C).
3) Tighten the screws (A).
Adjusting the flexible plate position
C
D
UN41-0711MP
For this operation, proceed as outlined below.
1) Loosen the wing nut (A).
2) Turn the lock lever (B).
3) Push the ploughshare forwards and turn it so it is
facing downwards.
4) Loosen the nut (C).
5) Turn the element (D) to position the flexible plate
(G) with respect to the ploughshare (F) as shown in
English language
ADJUSTMENT INFORMATION
A
E
B
C
NOTICE
Check that the flexible plate does not rub against the
ploughshare.
F
G
the figure.
6) Tighten the nut (C).
7) Refit the share in the work position.
8) Check that the Plant Control device (E) is inside the
share.
9) Make sure that the share is secured in place with the
lock lever (B).
10) Tighten the wing nut (A).
22
5
= =
B
Use and maintenance