Checchi & Magli BABY TRIUM Manuel D'utilisation Et D'entretien page 72

Loading, transporting and unloading the work vehicle
Decide whether it is more appropriate to lift the machine
or to use the ramps to load the machine onto the means
of transport.
After loading the machine, secure it on the means of
transport with wedges and ropes.
Affix the relative signalling signs to any parts jutting out
from the means of transport.
The machine must be lifted as shown (see "Lifting the
BABY TRIUM " and "Lifting the BABY TRIUM DT").
Machine loading onto and unloading from the means of
transport using the ramps providing access to the truck's
bed.
WARNING
Before getting the machine on and off the transport
means clean the ramps and truck bed accurately.
Where the ramps meet the truck bed there is a dan-
gerous bump so move the machine very carefully
over this point.
English language
INFORMATION CONCERNING HANDLING AND INSTALLATION
For this operation, proceed as outlined below.
1) Start the tractor and lift the work vehicle as far off the
ground as is permitted.
2) Get into the means of transport from the tractor's
driving seat.
3) Lower the work vehicle onto the truck bed.
4) Off the tractor engine and engage the parking
brake.
5) Anchor the work unit -tractor assembly to the means
of transport with ropes and secure the wheels with
wedges.
18
4
Use and maintenance