Checchi & Magli BABY TRIUM Manuel D'utilisation Et D'entretien page 62

Guards
WARNING
Never use the machine without the safety guards.
The work vehicle is fitted with guards covering the trans-
mission components to prevent accidental contact with
the moving parts.
F
A
UN41-0698EO
Information and safety signs
WARNING
Check that all the plates are legible; if they are not,
clean them or - if they are damaged - replace them,
applying the new ones in the same place as the old
ones.
A) Hazard plate: read the use and maintenance manual
before using the work vehicle.
B) Hazard plate: switch off the tractor; remove the igni-
tion key and store in a safe place before carrying out
any type of work on the work vehicle.
C) Hazard plate: do not remain on the seat with the
work vehicle lifted off the ground.
English language
TECHNICAL INFORMATION
RAPID SHIFT
B
D
C
8
The picture shows the casings fitted to protect the mov-
ing parts.
The casings (C - D) are fitted on each driving wheel.
The casings (A - B - E) are fitted on each planting unit.
The casing (F) is fitted on each driving wheel with the
Rapid Shift gearbox.
D) Information plate: strap up at the anchor points
shown to lift the work vehicle.
E) Hazard plate: this highlights a risk of hands being
crushed between the dispenser and the dispenser
disc.
F) Plant spacing plate: this shows the type of pinion to
fit according to the plant spacing required.
G) Plant spacing plate: applied on the "right Rapid
Shift" wheel, it indicates the pinions to be selected,
according to the plant spacing.
H) Plant spacing plate: applied on the "left Rapid Shift"
wheel, it indicates the pinions to be selected, accord-
ing to the plant spacing.
2
E
D
C
Use and maintenance