Checchi & Magli BABY TRIUM Manuel D'utilisation Et D'entretien page 101

Replacing the ploughshare
B
UN41-0729EO
For this operation, proceed as outlined below.
1) Move lever (A) and turn the guide (B) downwards, if
the skid is fitted.
2) Remove the circlip (C).
3) Unscrew the wing nut (D).
4) Remove the washer (G).
5) Lift and hold the clamping device (E).
6) Push the share forwards and turn it so it is facing
Replacing the slider
UN41-0285GI
WARNING
During disassembly, watch out for the elasticity of
the slider since, when it is released from the rail, it
springs back to the starting position (straight) and
could cause injury.
English language
INFORMATION CONCERNING REPLACEMENTS
A
downwards.
7) Hold the ploughshare and remove the screw (F).
8) Fit the new ploughshare.
For the assembly, carry out the same operations as for
disassembly but proceeding in reverse order.
NOTICE
During assembly, fit the Plant Control device inside
the ploughshare.
When the slider wears down to a thickness of 6 mm, it
must be replaced.
47
8
C
B
A
Use and maintenance