Troubleshooting; Scrapping - Nilfisk SC401 Instructions D'utilisation

TROUBLESHOOTING

TROUBLE
The motors are not operating; the button LEDs do
not turn on.
The scrubbing/drying function does not start.
The dirty water vacuuming is insufficient.
The solution flow to the brush is insufficient.
The squeegee leaves marks on the floor.
(*) This maintenance procedure must be performed by an authorised Nilfisk Service Center.
For any further information, contact Nilfisk Service Centres.

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Brushes
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Nilfisk Center especially when scrapping electrical and electronic components.
Machine material composition and recyclability
Type
Aluminium
Electric motors - various
Ferrous materials
Wiring harness
Liquids
Plastic - non-recyclable material
Plastic - recyclable material
Polyethylene
Rubber
09/2017
INSTRUCTIONS FOR USE
POSSIBLE CAUSE
The power supply cable or plug is broken.
The main switch is broken.
The control panel is broken.
The operator's presence sensors are broken.
The recovery tank is full.
The vacuum grid is clogged or the float is
stuck closed.
Debris collection filter container clogged.
The hose is disconnected from the squeegee. Connect.
The squeegee is dirty or the squeegee blades
are worn or damaged.
The tank cover is not properly closed, or the
gasket is damaged.
Empty detergent solution tank.
The solution filter is dirty.
There is debris under the squeegee blades.
The squeegee blades are worn, chipped or
torn.
The squeegee has not been balanced with the
handwheel.
Recyclable
percentage
9100002292 - SC401, SCRUBTEC 344
Replace the cable. (*)
Replace. (*)
Replace. (*)
Replace. (*)
Empty the tank.
Clean the vacuum grid.
Clean.
Clean the squeegee or overturn/replace the
blades.
Correctly close the cover or clean/replace the
gasket.
Refill.
Clean the filter.
Remove the debris.
Overturn or replace the blades.
Adjust the squeegee.
100 %
29 %
100 %
80 %
100 %
0 %
100 %
92 %
20 %
ENGLISH
REMEDY
Weight %
5 %
29 %
8 %
3 %
0 %
1 %
6 %
46 %
2 %
19