Maintenance; Scheduled Maintenance Table; Power Supply Cable Check - Nilfisk SC401 Instructions D'utilisation

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed with the machine switched off and the power supply cable plug
disconnected from the electrical mains.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
This Manual describes only the simplest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Squeegee Cleaning
Brush/pad cleaning
Tank, debris tray, and vacuum grid with float cleaning, and cover
gasket check

Power supply cable check

Squeegee blade check
Solution Filter Cleaning
Squeegee blade replacement
POWER SUPPLY CABLE CHECK
1. Carefully check the power supply cable (5) and the relevant plug for wear, cuts, cracks or other damages.
If the power supply cable or the relevant plug is damaged, contact the Nilfisk Service Center before using the machine again.
09/2017
INSTRUCTIONS FOR USE
Daily, after using
the machine
9100002292 - SC401, SCRUBTEC 344
Every six
Weekly
months
ENGLISH
Yearly
15