Tank Emptying; After Using The Machine; Machine Long Inactivity - Nilfisk SC401 Instructions D'utilisation

ENGLISH

TANK EMPTYING

An automatic shut-off float system (28) turns off the vacuum system when the recovery tank (30) is full.
The vacuum system deactivation is signalled by a sudden increase in the vacuum system motor noise frequency, and the floor is
not dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the float is activated because of a sudden
machine movement), to resume the operation: turn off the vacuum system by pressing the push-button (44),
then open the cover (31) and check that the float inside the grid (28) has gone down to the water level. Then
close the cover (31) and turn on the vacuum system by pressing the push-button (44).
When the recovery tank (30) is full, empty it according to the following procedure.
Recovery tank emptying
1. Lift the brush deck by pressing the pedal (9-A).
2. Lift the squeegee (26) with the lever (7).
3. Drive the machine to the appointed disposal area.
4. Turn off the machine with the push-button (42, LED off) and the main switch (41) to "0".
5. Empty the recovery tank (30) with the drain hose (11). Then, rinse the tank with clean water.
Solution tank emptying
6. Perform steps 1 to 4.
7. Empty the detergent solution tank (18) using the level hose (12). Then, rinse the tank with clean water.

AFTER USING THE MACHINE

After working, before leaving the machine:
1. Turn off the machine with the push-button (42, LED off) and the main switch (41) to "0".
2. Disconnect the power supply cable plug (4) from the electrical mains and place it on the holder (5).
3. Remove the brush (24) as shown in the relevant paragraph.
4. Empty the tanks (30 and 18) as shown in the previous paragraph.
5. Perform the daily maintenance procedures (see the Maintenance chapter).
6. Store the machine in a clean and dry place, with the brush and the squeegee lifted or removed.

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After Using the Machine paragraph.
2. Close the solution tank valve (25-B).
14
INSTRUCTIONS FOR USE
SC401, SCRUBTEC 344 - 9100002292
09/2017