Mouting Location - IMEON ENERGY HV Notice De Montage Et Guide De Montage

IMEON HV
5. Installation
5.1.

Mouting Location

 Do not mount the inverter on flammable construction materials.
 Mount on a solid surface.
 IMEON may possibly be noisy during operation which would be uncomfortable if
installed in a living room area.
 The temperature may cause a reduction of power due to the excessive heating.
 Install the IMEON at eye level in order to allow the LCD display to be read at all
times.
 Dusty conditions may impair the performance of this inverter.
 Do not switch IMEON on, if the temperature or the humidity are out of the
authorized limits.
 For proper air circulation to dissipate heat, allow a clearance of approx. 50 cm to
the side and approx. 50 cm above and below the IMEON.
 For proper operation of this inverter, use appropriate cables for grid connection.
 For the appropriate functioning of this inverter, use adapted cables cross- section
(taking into account the length of cables, the mode of installation, the impedances,
currents and voltage).
 The recommended installation position (vertical) is to be adhered to.
 Installation must be adapted to the weight and the dimensions of the inverter.
Please avoid direct sunlight, rain exposure, snow laying up during installation and
operation.
IMEON HV – Guide d'installation / Installation guide – Rev A.4
FR
EN
FR
45