IMEON ENERGY HV Notice De Montage Et Guide De Montage page 50

Step 1: Make sure the nominal voltage of the battery corresponds to the technical
Step 2: Check polarity of the battery bank and identify the positive "+"and the negative
WARNING: Incorrect polarity of the battery bank will damage the inverter! Check the
system before connecting the batteries.
Step 3: Switch the breaker and fuses to OFF position, in order to avoid electric arcs and the
FR
EN
FR
Step 4: Use two battery cables section 6mm². Remove 15 mm of the insulation sleeve.
Step 5: Insert the positif cable (+) into the positive battery connector (+)
Step 5:
Step 7:
50
IMEON HV
specifications of the inverter.
"-" terminals.
risk of damage.
Insert the negatif cable (-) into the negative battery connector (-)
Press down spring until it clicks audibly into place (it must be possible to see the
fine wire strands in the chamber).
Tighten the screw connection (torque:2.0Nm).
IMEON HV – Guide d'installation / Installation guide – Rev A.4