IMEON ENERGY HV Notice De Montage Et Guide De Montage page 61

IMEON HV
Setting
It provides access to the UPS settings:

Date Time: Allows to modify the date and time of the inverter

Buzzer: Enables or disables the buzzer in case of an alarm on the inverter

Advanced: Provides access to advanced settings
o Safety: Used to set the standard
o Working mode: allows you to configure the mode of use of the inverter (see
the different modes of use below)
o Bat. Para. : Used to select the battery used and manage the high and low
discharge thresholds
o Export Limit: Allows you to configure the maximum power injected into the
grid
o Reset: Allows to delete the history
Note: All advanced parameters can only be changed by installers with the skills to do so.
The access password is: 1111.
Switch
It is used to synchronize / desynchronize the inputs / outputs when the inverter is turned
on and off
About
It contains different software and firmware versions of the inverter.
Work Mode
There are different work modes.

Self-use: This is the default mode and the one used in the vast majority of
installations. PV power is used to supply consumers, then charge the battery if there
is a surplus, then inject the surplus into the public grid if the battery is full.
When solar production is insufficient or non-existent, the battery is used to power
consumers. The network takes over when the battery is also empty.

Force time use: This is the "Self-Use" mode with the particularity that you can
activate periods of forced battery charging to take advantage of the off-peak hour
rate. So :
Outside these periods, the principle remains the same as the "Self-Use"
o
mode.
o
During these periods, PV power is used to charge the battery as a priority,
then to supply consumers in the event of excess production or full battery,
then inject the surplus into the public grid in the event of full battery. It is
IMEON HV – Guide d'installation / Installation guide – Rev A.4
FR
EN
FR
61