IMEON ENERGY HV Notice De Montage Et Guide De Montage page 64

AC10M Volt Fault
DCI OCP Fault
DCV OVP Fault
FR
SW OCP Fault
EN
FR
RC OCP Fault
Isolation Fault
Temp Over Fault
BatConDir Fault
Sample Fault
EPS OCP Fault
Over Load Fault
64
IMEON HV
Faults
The grid voltage is out of range for the last 10 Minutes.
The system will back to normal if the grid is back.
Or seek for help from us.
DCI over current protection Fault.
Wait for a while to check if back to normal.
Or seek for help from us.
DCV EPS over voltage protection Fault
Wait for a while to check if back to normal
Or seek for help from us.
Over current fault detected by software.
Wait for a while to check if back to normal.
Turn off the PV, battery and grid, reconnect them.
Or seek for help from us.
DCI over current protection Fault
Please check if the insulation of electric wires is damaged.
Wait for a while to check if back to normal.
Or seek for help from us
Isolation Fault
Please check if the insulation of electric wires are damaged.
Wait for a while to check if back to normal.
Or seek for help from us.
Temperature over the limitation
Check if the environment temperature is over limitation.
Or seek help from us.
Battery Reverse Connection Fault
Check if the positive pole and negative pole of battery are
connectedin a contrary way
Or seek help from us.
The detection circuit Fault
Disconnect PV+ / PV- and battery, reconnect them.
Or seek help from us.
Over Current in EPS Mode
Make sure the load power is within the EPS power range
Check if any nonlinear load is connected on the EPS. Remove this
load to check if can recover
Or seek help from us, if cannot go back to normal state.
Over Load
Turn off high power device. Reset of over load error is necessary to
allow inverter operation again.
IMEON HV – Guide d'installation / Installation guide – Rev A.4
Diagnosis and solution