Ground Connection; Battery Connection; Power Cable Connection - IMEON ENERGY HV Notice De Montage Et Guide De Montage

IMEON HV
5.5.

Ground Connection

WARNING: It is necessary to connect the frame of IMEON to the earth ground in
order to prevent the electric shock.
Use earth ground cables, connect ground on location marked in section 2.3, point 10.
Ensure the earth ground wire is properly connected before turning on the IMEON inverter.
5.6.

Battery Connection

5.6.1. Power cable connection

WARNING:It is very important for system safety and efficient operation to use
appropriate cables and to install the system in a correctly ventilated area.There is a risk
related to the voltage and current of the battery. It is necessary to cover the battery
terminals.
Note: In case of Lithium battery, charge and discharge currents are dynamically
imposed by the battery's BMS. It is necessary to ensure that the consumption on EPS
does not exceed the discharge current of the battery, otherwise the inverter will go into
error when the grid is unavailable.
Note: In the case of a Lithium battery, at the request of the Battery Management System, a
charge of the battery by the network can be done in order to secure the battery
(balancing charge).
WARNING:Before connecting to the batteries, please install DC circuit breaker and
fuses between inverter and batteries according to the existing standards.
The IMEON inverter can only work with high voltage batteries from the manufacturer
PYLONTECH (H48050 Battery). The number of modules must be between 3 and 7 and
the number of BMS (SC1000 Controller) is 1 maximum.
IMEON HV – Guide d'installation / Installation guide – Rev A.4
FR
EN
FR
49