Maintenance & Cleaning; Fault Codes - IMEON ENERGY HV Notice De Montage Et Guide De Montage

IMEON HV
5. Maintenance & Cleaning
5.1.

Fault codes

This section contains information and procedures in case of fault.
Check warnings or fault messages on System Control Panel or Fault codes on the inverter
information panel. If a message is displayed, record it before doing anything further.
Attempt the solution indicated in below table.
Faults
Over current Fault.
Wait for a while to check if go back to normal status.
TZ Protect Fault
Disconnect PV+\ PV- and battery, reconnect them.
Or seek help from us, if ca not go back to normal state.
Grid is Lost.
Please wait for a while and system will reconnect if the utility is back
to normal.
Grid Lost Fault
Please check whether the cable connection at AC side is normal or
not.
Or seek help from us.
Grid Voltage Out of Range
Please wait for a while and system will reconnect if the utility is back
Grid Volt Fault to normal.
Please check whether the grid voltage is in the normal range.
Or seek help from us.
Grid Frequency Out of Range
Grid Freq Fault System will reconnect if the utility is back to normal.
Or seek help from us.
PV Voltage Out of Range
PV Volt Fault Check the output voltage of the PV panels.
Or seek for help from us.
Bus Voltage Out of Normal Range
Disconnect PV+ / PV- and battery, reconnect them.
Bus Volt Fault
Check if the PV input is within the range of the inverter.
Or seek help from us, if cannot go back to normal state.
Battery Voltage Fault
Bat Volt Fault Check if the battery input voltage is within the normal range
Or seek help from us
IMEON HV – Guide d'installation / Installation guide – Rev A.4
Diagnosis and solution
FR
EN
FR
63