Maintenance & Cleaning; Warning And Error Codes - IMEON ENERGY IMEON 3.6 Manuel D'installation

8. Maintenance & Cleaning

8.1 Warning and error codes

Warning and error codes In case of a warning or error displayed by the inverter, refer to the table
below before contacting technical support if needed.
1 warning_ond
2 warning_ond
3 warning_ond
4 warning_ond
5 warning_ond
6 warning_ond
7 warning_ond
FR
9 warning_ond
FR
EN
10 warning_ond
11 warning_ond
12 warning_ond
13 warning_ond
14 warning_ond
15 warning_ond
22 warning_pv
23 warning_pv
24 warning_pv
25 warning_cpu
26 warning_cpu
27 warning_bat
30 warning_bat
32 warning_bat
35 error_ond
37 error_soft
38 error_soft
39 error_soft
40 error_soft
41 error_soft
42 error_pv
43 error_pv
44 error_pv
45 error_ond
46 error_ond
47 error_ond
48 error_ond
49 error_ond
50 error_ond
88
IMEON INVERTER
The electrical grid has perturbations.
The electrical grid has perturbations.
The electrical grid has perturbations.
The electrical grid has perturbations.
The electrical grid has perturbations.
The electrical grid has perturbations.
The electrical grid has perturbations.
Internal temperature nears the inverter temperature limit.
A battery warning has been reported.
Communication failure with processor1.
Processor2 operating system failure.
Failure reading/writing on database.
Manuel d'installation / Installation guide IMEON Inverter – Rev B.5
Electrical grid loss.
Wrong phase rotation.
Electrical grid loss.
Overload on AC Output with Grid.
Earth fault.
Fan fault.
Low PV 2 voltage.
PV voltage too high.
PV2 voltage too high.
Processor1 flash failure.
Processor1 initialization failure.
Battery not connected.
Battery voltage too high.
Internal wiring failure.
software service failure.
Software failure on processor2.
Solar input overvoltage.
Solar input overcurrent.
Solar isolation resistance too low.
DC Bus overvoltage.
DC Bus undervoltage.
DC Bus circuit start timeout.
Inverter main circuit start timeout.
Inverter overcurrent.
Overheating.