Configuration For Ethernet Connection; Configuration For Wi-Fi Connection - IMEON ENERGY IMEON 3.6 Manuel D'installation

7.1 Configuration for Ethernet connection

1. Connect the inverter with an Ethernet cable
(RJ45) from "ETH" port to an access point.
2. Check if the DEL of « ETH » port are blinking
3. On a PC connected to the same Ethernet
network, through the network explorer, check
if an IMEON device is displayed.
4. The inverter is connecter to the access point.
Go to the web portal identification step.
FR
FR
EN

7.2 Configuration for Wi-Fi connection.

1- Connect to MANAGER WEB, then go to

Local
.
2- Press "List connection" to scan and display
the list of Wi-Fi networks available for the
inverter.
3- In the list of identified networks, press "Select"
to establish connection with the chosen
network.
4- Enter the network key (if required), then click on "Connect".
5- The name of the Wi-Fi network selected is
displayed on « Wireless station name » and
the status is « connected »
6- The inverter is connected to the access point. Go to the web portal identification step.
84
IMEON INVERTER
Wi-Fi
Manuel d'installation / Installation guide IMEON Inverter – Rev B.5