Compatibility - IMEON ENERGY IMEON 3.6 Manuel D'installation

IMEON INVERTER
The inverter is equipped with several communication ports: RS485, Ethernet, CAN, USB, Wifi, RELAY and
sensor ports (Ecap, Tcap).
- RS485: to communicate with specific devices
- Ethernet: to connect with a local area network
WiFi: to connect with a wireless network (router, PC, mobile...)
-
- CAN: to communicate with lithium batteries (only batteries compatible with IMEON)
- USB: to communicate with an USB device
- RELAY: to control a diesel generator
- Tcap: temperature sensor
- Ecap: current sensor
RS485
RS485

2.2 Compatibility

IMEON Smart Inverter is designed to manage the continuous power of three different sources of
energy: solar panels, the batteries, and the grid.
IMEON uses the maximum power point technology (MPPT) to optimize the maximum quantity of
energy supplied by the solar panels. When the solar panels voltage input falls in the inverter's MPPT
range, the IMEON Smart Inverter will supply the consumption and charge batteries simultaneously.
IMEON smart inverters are only compatible with mono-crystalline and poly-crystalline PV modules.
Concerning thin films panels, it is necessary to check their compatibility with transformerless inverters
and follow the PV manufacturer recommendation as well as IMEON's specification.
Some precautions must be realized to make sure that the maximum open circuit voltage never
exceeds the inverter's specifications. Please note that the maximum voltage will occur in the lowest
temperature planned. You will find detailed information about the influence of the temperature in the
manufacturer datasheet of the PV modules.
IMEON is compatible with lead and lithium batteries. Please consult the IMEON website (as well as
your IMEON distributor) to check the list of the lithium batteries supported.
Manuel d'installation / Installation guide IMEON Inverter – Rev B.5
Gigabit
Current
USB-A
Ethernet
Sensor
CAN
USB-A
Temperature
Sensor
Relay
WiFi
FR
FR
EN
57