Load (Ac Output) Connection - IMEON ENERGY IMEON 3.6 Manuel D'installation

IMEON INVERTER
3.8.2 Grid Connection for IMEON 9.12
WARNING: Check phase shift rotation clockwise L1, L2 and L3. In case of phase inversion, the
inverter will start but will not be synchronized with the public grid.

Connect the phases L1 to «L», L2 to «1» and L3
to «2».

Connect the neutral wire to the symbol « N »

Connect the Earth wire to the symbol «
2
3
Step 4: Make sure the wires are securely connected.
Step 5: Plug the RST connector in the GRID
CONNECTION socket.

3.9 Load (AC OUTPUT) connection

WARNING: It is very important for the safety and efficiency of the system to use the appropriate
AC connection cables.
WARNING: Please use maximal protection according to the existing standards (circuit breaker,
differential current breaker). The circuit breaker must protect against currents exceeding the
maximum output current of the inverter (17 A per phase). Use a circuit breaker Type A 30mA.
Note: The inverter current (battery + PV) cannot exceed 13A nominal per phase. In the case of grid
outage, make sure not to go over this figure.
Note: In case of the operation with PV only (grid outage and no battery), the AC OUTPUT of the
inverter will not be activated.
Note: To prevent further supply to the load via the inverters AC OUTPUT during any mode of
operation, an additional disconnection device should be placed in the buildings wiring
installation.
Manuel d'installation / Installation guide IMEON Inverter – Rev B.5
1
»
FR
FR
EN
67