IMEON ENERGY IMEON 3.6 Manuel D'installation page 65

IMEON INVERTER
Insulate the cable on a length « L » of 6 to
7,5mm
Visually check the crimp
Step 6: Connect each input to the corresponding mounted connector of the inverter.
Connect negative pole (-) of connection cable to negative pole (-) of PV input connector.
Connect positive pole (+) of connection cable to positive pole (+) of PV input connector.
1 input for IMEON 3.6
Manuel d'installation / Installation guide IMEON Inverter – Rev B.5
Insert the striped cable on the crimping tool, then
press
Insert the crimped-on contact into the insulator of
the male or female coupler until it clicks into place.
Pull gently on the lead to check that the metal part
is correctly engaged.
2 inputs for IMEON 9.12
PV1 Input
FR
FR
EN
PV2 Input
65